battery question!

[nexusmaximus]

i was trying to fit a permenant optimate connector to the battery. i moved the two rubber covers for the positive and negative terminals, but i couldn't loosen the bolts with the usual amount of force. before i open up a party seven of whoop ass on these bolts, is there something i'm missing, before i do? is there an outside chance i could break the terminals, or have any of you guys had the same problem, at your first attempt? it's also a little awkward to get under the seat, and gain access to the battery.

[Deleted User 62]

Party Seven!!!!.... ....You could get into a Party Seven!

[nexusmaximus]

yep! i'm old school in philosophy, clive... if not quite there in age.

[Normsthename]

Is there something i'm missing, before i do?

Righty tighty lefty loosy

Andy

[richie the 1st]

If you break 1 you got 3 more batterys on your 3 other scoots to use...

[nexusmaximus]

thank you richie! very helpful.

[richie the 1st]

Thats ok barry seing as i have only 1 off-road scoot.

[nexusmaximus]

Is there something i'm missing, before i do?

Righty tighty lefty loosy

Andy

i did go through the usual ''am i turning this the right way?'' self questioning.

[nexusmaximus]

cheers meldrew, i just like to be sure... thanks!

[road runner]

Barry,

Recently did same on mine and didn't have a problem in loosening the bolts.
Also, if its not too late, I found that by removing the hydraulic stay from the seat (only has a pull out 'R' circlip pin) at one end, it enabled me to lift the seat higher and by proping it up with a suitable length of timber, access was much better.

road runner