What have you done to your Scooter today?

[Globs]

Took it for a local run tried it up some hills not bad for 171 cc keeps up with traffic OK

Those HD200/Joyride200 engines are really tractable, my Joyride will wind me and the missus up fairly steep hills without any issue and without needing full throttle either, it's only at motorway speed you notice the wallet protecting engine size.

[pikey]

I get feeling l it will cruise at 60 with me on not gone that fast yet .For what I paid I'm happy so far .

[StevenM]

I made some tie downs for Steve today, not as sexy as those as my only good file died on the 3mm stainless...mind in an earlier life it had been part of a toxic chemical container i was going to give it a bit of a rounded look but then the file died so it went all square on the mill

Thanks buddy they will do the job

[Globs]

You'll probably need a diamond coated file for stainless, it's very hard stuff!!
Tie downs look good BTW.

[Funkycowie]

Fitted my wrapped panels back on the TMax... front end is all matt black with gloss red and white bits rear is yellow as in my avatar... it looks fooking odd and ugly lol

[Deleted User 5490]

Changed the oil , fitted rear pads. mashed up some brake fluid reservoir lid screws.
What I wanted to do was all of the above AND wash it down, add antifreeze , put my Italian apron , put my Givi Rack and bunjees on and for the first time in my 5yr 30k history , use some product to make the panels black again.

[kayz1]

sorite mate thanks for the goodies..

[muddyfox]

Photos please Funkycowie.

[Funkycowie]

Photos please Funkycowie.

Don't say I didn't warn you how ugly it looks!

It's a bit of a Frankenscoot right now

NewColorScoot.jpg

I still have 15 panels, large and small, I need to wrap for the final look. The wife has been taking me to and from work but her car is going in for a respray due to a paint defect on the roof so I need a working scoot.

[muddyfox]

Thanks Funkycowie. If that's only work in progress cannot wait to see finished scooter.