Wishing I had one and a job!

added a couple of strips of yellow vinyl wrap, washed it, re-attached the Ermax Hugger as it was coming off due to a dodgy screw, thought about cutting a screen down but didn't... will probably do it next weekend.

Stuck some new Michelin City Grip tyres on the SH300 today. Early days yet but seem a nice tyre with a progressive, predictable turn in. They replaced a mix of a Bridgestone Hoop on teh rear and a absolutely dreadful Avon Atrye or Spyke on the front.

Also put some new brake pads on it too. Goes for its MOT next weekend. Just nudging 57k and still running without fault.

Left it in for service. Can't wait to pick it up tomorrow and I hope that everything will work as they should.

hmmmmmm.. very nice lad a review is needed.

10 minutes oil and oil filter change in the office car park... more coming tomorrow lunch time

New iridium plugs are fitted... Holy moly... had to remove around 12 bolts to get there.

Btw, I got a big earful from the building manager to fixing my bike in the office car park, she thinks I am going to damage the tarmac

The MK3 is x24 screws, x2 Bolts, x10 plastic pushpins... although it can be done with only x7 screws and x3 pushpins but access is a bit restricted.

Fitted some datatool heated grips, can fit direct to the battery as they will not work without the engine running, so no flat batt,very tidy fitment no square control box, simple slider on the left grip. Well pleased

Cut down a spare OEM screen using my cordless dremel, now I am waiting for it to recharge so I can tidy up the edges.