What have you done to your Scooter today?

[Funkycowie]

Coolant change to a 5 year type, flush with 8 litres of water before hand as I was going from green to red.

Checked tyre pressures and gave her a wipe down for the Pie and Mash ride tomorrow

[Funkycowie]

Somethings different...

IMG_20150815_122512-(2).jpg

Apologies for the dirtiness, she's getting a wash later.

[StevenM]

Stripped the Tmax down today. I wanted to check the V belt as it has a full service history but no reference to what as been done. Belt looks brand new. Also fitted my £9.99 alarm.

[Funkycowie]

Tmax belts will still look new after 12000 miles of use, did you measure it?

There's only a 1.5mm tolerance, 32mm fresh, down to 30.5mm limit.

[StevenM]

Tmax belts will still look new after 12000 miles of use, did you measure it?

There's only a 1.5mm tolerance, 32mm fresh, down to 30.5mm limit.

No I didn't, the whole thing looked in mint condition and no black dust inside from belt wear. Its at 18500 with full service last one done about 17500.

[Funkycowie]

In the last service they may have looked and cleaned the case but not measured or changed.

[StevenM]

will check again this week, I'm off all week. am I measuring from the top teeth to the bottom teeth

[bornagainbiker]

will check again this week, I'm off all week. am I measuring from the top teeth to the bottom teeth

It's the across the width Steve.

[StevenM]

will check again this week, I'm off all week. am I measuring from the top teeth to the bottom teeth

It's the across the width Steve.

Thanks mate

[2wheelover51]

This morning I lifted the n/s foot mat and fitted a penny washer under the front allen screw to secure the plastic tab which had parted company instead of holding the underpanel on.
Last week I fitted a "mudflap" which goes in front of the rear wheel to keep all the road dirt off the rear of the engine cases and upper parts of the swingarm. I also painted "Waxoyl" over all exposed metal..