Hi
we have a 400 Burgman 400 with carb and ecu
I think it is a K1 or K2 about year 2000
we want to put the burgman motor in a 3 wheeler
so my question is how do we wire up the ecu to run out of the bike ?
we have all the carb and other bits
so my guess is it just needs power

can any one help

Thanks

well its a lot easier with a wiring diagram, then you wont be in the dark with regards to what goes to where so one below, for 250/400 burgman K1 K2 models


direct link to image here http://i1201.photobucket.com/albums/bb3 ... crtvv8.jpg

or PM me your email address and i will send it, so you can print of or blow it up ( the image not the engine ) good luck lad